;     file name: Restored backup.tap
; date and time: Tue Nov 09 2021    02:51:54
; postprocessor: plasmacrodw.scpost rev: 0.4
;
;begin pre-amble
 G21 (units: metric)
 G40 (cutter compensation: off)
 G90 (distance mode: absolute)
 M52 P1 (adaptive feed: on)
 M65 P2 (enable THC)
 M65 P3 (enable torch)
 M68 E3 Q0 (velocity 100%)
 G64 P0.254 Q0.025 (tracking tolerances: 0.254mm)
#<holes>      = 2
#<h_velocity> = 60
#<h_diameter> = 32
#<oclength>   = 4
;end pre-amble
;
;begin material setup
 T0 M6 (select plasma tool)
 G43 H0 (apply tool offsets)
 (o=0,kw=1.2, ph=3, pd=0.5, ch=1.5, fr=100, cv=99, pe=0, jh=0, jd=0)
 F#<_hal[plasmac.cut-feed-rate]>
;end material setup
 G0 X18.765 Y122.809
 M3 $0 S1 (plasma start)
 G2 X18.765 Y122.809 I1.192 J1.192
 M5 $0 (plasma end)
 G0 X18.765 Y168.298
 M3 $0 S1 (plasma start)
 G2 X18.765 Y168.298 I1.192 J-1.192
 M5 $0 (plasma end)
 ;
 ;begin post-amble
 G40 (cutter compensation: off)
 G90 (distance mode: absolute)
 M65 P2 (enable THC)
 M65 P3 (enable torch)
 M68 E3 Q0 (velocity 100%)
 M5 $-1 (backup stop)
 ;end post-amble
 ;
 ;begin statistics
 ;Pierces = 2
 ;   Cuts = 2,    Length = 21.19mm
 ;end statistics
 ;
 M30 (end program)