[MB2HAL_INIT]
INIT_DEBUG=0
SLOWDOWN=0.0
TOTAL_TRANSACTIONS=3
VERSION = 1.1

[TRANSACTION_00]

LINK_TYPE=serial
SERIAL_PORT=/dev/ttyUSB0
SERIAL_BAUD=38400
SERIAL_BITS=8
SERIAL_PARITY=none
SERIAL_STOP=1
PROTOCOL=RTU
SERIAL_DELAY_MS=10
MB_SLAVE_ID=1

FIRST_ELEMENT=0
NELEMENTS=1
MB_TX_CODE=fnct_04_read_input_registers
MB_RESPONSE_TIMEOUT_MS=500
MB_BYTE_TIMEOUT_MS=500
HAL_TX_NAME=spindle-speed
MAX_UPDATE_RATE=0.0
DEBUG=1

[TRANSACTION_01]
FIRST_ELEMENT=3
NELEMENTS=1
MB_TX_CODE=fnct_01_read_coils
MB_RESPONSE_TIMEOUT_MS=500
MB_BYTE_TIMEOUT_MS=500
HAL_TX_NAME=spindle-at-speed
MAX_UPDATE_RATE=0.0
DEBUG=1

[TRANSACTION_02]
FIRST_ELEMENT=3
NELEMENTS=1
MB_TX_CODE=fnct_06_write_single_register
MB_RESPONSE_TIMEOUT_MS=500
MB_BYTE_TIMEOUT_MS=500
HAL_TX_NAME=spindle-set-speed
MAX_UPDATE_RATE=0.0
DEBUG=1

#REQUIRED: Modbus transaction function code (see www.modbus.org specifications).
#    fnct_01_read_coils               (01 = 0x01) (new in 1.1)
#    fnct_02_read_discrete_inputs     (02 = 0x02)
#    fnct_03_read_holding_registers   (03 = 0x03)
#    fnct_04_read_input_registers     (04 = 0x04)
#    fnct_05_write_single_coil        (05 = 0x05) (new in 1.1)
#    fnct_06_write_single_register    (06 = 0x06)
#    fnct_15_write_multiple_coils     (15 = 0x0F)
#    fnct_16_write_multiple_registers (16 = 0x10)