New Configuration Error

Helping a guy run configurator to get his table going for the first time. Afterward, encountered this error on start-up "signal 'spindle-at-speed' not found".

It turns out that this line regarding the spindle was not commented out, and caused the problem:

Commenting it out solved the problem. If I recall, I think the configurator was recently updated to comment out spindle lines, it looks like perhaps one slid through the cracks.

I had the same issue a few days ago. I got rid of anything spindle related.

Kale Dobrohoczki wrote: I had the same issue a few days ago. I got rid of anything spindle related.

Same, but without reporting it, we can't fix it for the next guy who might not know how to fix it (as is the case with the guy I was helping). Good to know it wasn't just me though!

snowgoer540 wrote: Helping a guy run configurator to get his table going for the first time. Afterward, encountered this error on start-up "signal 'spindle-at-speed' not found".

It turns out that this line regarding the spindle was not commented out, and caused the problem:

Code:

sets spindle-at-speed true

Commenting it out solved the problem. If I recall, I think the configurator was recently updated to comment out spindle lines, it looks like perhaps one slid through the cracks.

Damn, I thought I fixed that. I'll take a look later on...

EDIT: I wish you guys would read the PlasmaC manual and disable anything not plasma related...

Haha! Read the manual. Funny guy :laugh:

There’s a lot of info in there, it’s tough to retain it all. Ironically, I did pass the link along to the new guy though and told him to get reading lol.

This "should" have been fixed in v0.139 - 2020 Jun 24

Can you post the original .hal file csusing this issue?