Beginner kinemetrics setup for linear delta?

andyhol wrote: I get the 403 result by doing it the console way as well.

So do I. I didn't on Friday.
I will make enquiries.

I got home from work and I was able to load scratch-rt. The simulator seems to be working, now I just need to get it hooked up to some motors; may be some research to refresh my memory on that part, it has been a while.

Thanks Guys

You probably want to start with the ldelta rather than ldelta_demo config to connect to real hardware.

Can I use StepConf to create the files for axis-es?
Example create a new config with stepconf called my-mill that sets all of the lpt pins, directions, speeds, etc; and then copy the .hal file to the ldelta dir and change the name?

andyhol wrote: Can I use StepConf to create the files for axis-es?

I don't know if Stepconf has been updated in the JA branch to create JA-format configs.
Give it a try, see what happens.

I have finally been able to get back to this project, and I have run into errors when trying to actually hook up hardware.
I am running stepper motors with gecko drives via the lpt port. I modified the config files created by the step conf wizard but they bring up an error page and EMC wont run.

Any suggestions?

Thank You
Andy