×
Forum Header
Mach 3 conversion to Stepconf Wizard
- LinuksGuru
- Offline
- Junior Member
-
Less
More
- Posts: 29
- Thank you received: 2
02 Dec 2015 08:13 #66203
by LinuksGuru
Replied by LinuksGuru on topic Mach 3 conversion to Stepconf Wizard
Hi, John,
Is it possible to convert with this script Mach3 setup with 2 motors for driving X axis into the LinuxCNC gantry?
Or this have to be done manually?
Is it possible to convert with this script Mach3 setup with 2 motors for driving X axis into the LinuxCNC gantry?
Or this have to be done manually?
The topic has been locked.
- BigJohnT
-
Topic Author
- Offline
- Administrator
-
Less
More
- Posts: 7000
- Thank you received: 1175
03 Dec 2015 13:09 #66278
by BigJohnT
Replied by BigJohnT on topic Mach 3 conversion to Stepconf Wizard
Give it a try and see... but I would assume you will need to start with typical configuration then add the extra motor.
JT
JT
The topic has been locked.
- scalci
- Offline
- New Member
-
Less
More
- Posts: 5
- Thank you received: 1
14 Feb 2016 15:21 #70112
by scalci
Replied by scalci on topic Mach 3 conversion to Stepconf Wizard
Hi, BigJohn
Can you please assist me wig my xml file?
Rgs
Scalci
Can you please assist me wig my xml file?
Rgs
Scalci
The topic has been locked.
- andypugh
-
- Away
- Moderator
-
Less
More
- Posts: 23315
- Thank you received: 4944
23 Feb 2016 15:09 #70518
by andypugh
Replied by andypugh on topic Mach 3 conversion to Stepconf Wizard
The Stepconf wizard now contains the XML import facility.
The topic has been locked.
Time to create page: 0.082 seconds