Issue converting a Mach3 file for BZT PFE1010

Hi,

I am running linuxcnc 2.7.3 and tried to import with stepconf a Mach3 XML file that worked fine with my machine. The file is attached.
I have tried a lot of possible configurations to figure out what was wrong but could not make it. There is something wrong with pins 16 and 17 but could not figure out the correct mapping (Enable2 on Mach3, could not find out the matching parameter on linuxcnc).

Any help would be appreciated.

Gilles

gilles fleury wrote: There is something wrong with pins 16 and 17 but could not figure out the correct mapping (Enable2 on Mach3, could not find out the matching parameter on linuxcnc).

Maybe Axis.N.amp-enable-out ?