Please explain error measage

Double check the g64 line you've got 2 letters in there I think it's only a p.xxx

How much of the tool name should be in comments?
Now: M06 T1 End Mill (0.25 inch)
Should it be: M06 (T1 End Mill 0.250)

allenwg2005 wrote: How much of the tool name should be in comments?
Now: M06 T1 End Mill (0.25 inch)
Should it be: M06 (T1 End Mill 0.250)

M6t1(comment)
Or t1m6(comment)

OK, answered my own question, it loads the file just fine when I edit to read M06 (T1 End Mill 0.250) .
Now, how do I get the post to output the tool line this way?

Those comments were a result of the tool name in the tool table, I have those changed and the file loads fine.

I have G00 [ZH} in the post but there is no mention of it in the gcode file,
Why wouldn't it write that to the file?

]Actually you do:

M1 G64 P0.05 Q0.05
(Begin Footer)
G00 Z0.501 <<<<< here, but this depends on a setting from the vectric job.
M30
(End Footer)
%

it can be set on the Toolpaths tab, Toolpaths Operations, Setup Materials and Rapid Gaps, might be different on Aspire.
I only use Vcarve as i an not able to run Aspire on Linux.