Plasma THC

I would but i have never used it, just had a quick look when it was released.

Okay. I've followed the instructions in the link Grotius posted for the RIP/offsets, I have not been able to find where to implement the RIP in linuxcnc.

A RIP is LinuxCNC that Runs In Place ie it's not installed.

JT

Excellent, I was able to get it going. I'm backing up the Grotius files and wiring in my components. What's the best way to approach modifying the HAL from parport to hm2_eth?

David,

If you have a clean working mesa config for me for your Mesa ethernet card, for example done by the linuxcnc configuration wizard,
, or the provided config's by Mesa and this is working on your machine (tested), then upload your files here. I can take a look to modify it.

By working i mean, xyz axis is working and tuned. torch start commando by spindle on M3 is working. And later on you need
the thcad voltage in.

Excellent, I was able to get it going.

Was it difficult to install? If you had any difficulties, please let them know, i can react on that in the readme file.

@ Grotius
Sweet, thank you!

Other than installing the build dependencies taking a while, it was pretty easy; my experience with linux is very limited and I was able to get it. Decent instructions.

These files work, I can move the machine around but I'm getting errors that I believe are the soft-stops engaging, I've played with the switches and it doesn't seem to make a difference, just in case you see anything.