New electronics!

Any interest in a new controller electronics? I'm an electronics engineer and I've been tinkering with CNCs for about 2 years now. I recently developed my own electronics after getting tired of putting together bits and pieces. Its an integrated 4-axes controller with four 4A Toshiba drivers. It has multiple logic control inputs and works with LinuxCNC and Mach3/4. The idea was to make something that is useful to newbies and experienced users alike.

If this is something that might of interest to you, I'm crowdfunding the controller right now. Please let me know if you have any questions or comments.

You might do better on one of the better-known crowdfunding sites I had not heard of that one.
I don`t expect to use steppers again, but it does look like a good alternative to the G540.

A firmware that accepted EPP data for step counts and that generated step-pulses on-board might find fans (Though it would find competition from Pico PPMC and Mesa 7i43)