Mesa 7I76EU – Fixing „Unsupported ethernet device – No 7I76EU board found” Error

I'm having the exact same problem, has anyone figured out what's going on?

Tks

If mesaflash reported that error, update mesaflash
(instructions on the git site or above in this thread)

github.com/LinuxCNC/mesaflash

If LinuxCNC reported the issue, you need t o update LinuxCNC.

(You don't actually have to update LinuxCNC as it will work fine but will complain about the card every time you start LinuxCNC)
 

Hello. 
I'm new in this form. I couldn't config my Mesa Card 7i76EU, the PncConf doesn't show the 7i76eu. I'm using Linux CNC 2.9.8. Thanks in advance.

The 7I76EU is compatible with 7I76E hal/ini files, so you can
just select "7I76E" in pncconf.