7i92 cnc motion controller from aliexpress?

Using PNCconf – the Mesa card configuration wizard, you can complete the configuration.

has anybody build hardware to mesa 7i92 board, how has made all input optocoupler board and output safety wiring to stepper drivers, i think if can build own output safe board to connection port 1 and all input pin optocoupler board connection 2, and were found bit file were have all output at connector 1 and all input have at connector 2, then have logical perfect all in/out pins configured.

you can use the cheap 5Axis-BOB's

 

Firmware: 5ABOBx2D

cheapen hahaha, aliecpres card cost 40-50 $ and mesa genuine cost ower 100 $ lot different price, hobby users not have money waste ower 100 $ only small card, need be lot lot cheapen can buy hobby cnc card.
and second, why waste lot money buy etc 160$ card if all same can buy aliexpress 40$ lot different price and stupid if waste lot money if not really need.

aliexpress 7i92 have anyone used this card, how can use,https://www.aliexpress.com/item/1005011667901833.html?spm=a2g0o.detail.pcDetailTopMoreOtherSeller.1.7ccfDf5dDf5dYi

I am having a problem configuring the 7I92 card that I bought on AliExpress.
From what I understand, it's a cloned card. My problem occurs when I configure the P1 and 7i76-Analog Output tabs, the error appears as shown in the last photo. 
However, when I only configure the P2 tab, nothing happens; the card works and the EasyServo devices operate.
Now I need to configure other outputs to make the motor or spindle work, but this error occurs.
Has anyone else experienced a similar problem?