G54 problem with new installation

Hello

I made new installation of LCNC 2.7.15 with Stretch and 7i77 mesa board and i have couple of problems. First problem is G54 position. Everything is working but only two times when i power off the machine and turn on did not remember G54. Other times it remember OK. Power cycle i made is first shutting down LCNC and then PC and in the end i turn off the power. If storing G54 is not consistent should i write down G54 coordinates ??
Mu second problem is with input i put with Pncconf. Every input work like it should but only Cycle start and Abort doing nothing. Did not executes program or abort program. I see the signal came in Hal Configuration signal window so wiring is ok only LCNC not take aktions for this inputs.
Thanks

Cycle start and abort are configured for the Touchy screen, but looking at the code it doesn't get configured for any other.
Do you home the machine?


adding these two line to your custom_postgui.hal file:

net cycle-start halui.program.run
net abort halui.program.stop

Should make them work.

Yes I home the machine first. Thanks for the information i will try enter this two lines and reported latter.
Thanks

how wrong is G54 when it is inconsistent?

G54 It cames to zero.it did not remember after power off. but it happens once in 10 times not to remember and g54 came to zero. Same like i never make touch off. When it remember G54 it is very accurate.
Thanks

you also need to delete the var.bak file (if it is there in the machine file folder)
on my plasma i got the same problem and after i deleted that file it wars gone for some long time