Is my wire diagram correct?

Hello,
I am responding to your answer because I have a problem with my E-stop. The E-stop on my Axis interface always remains on Off
“net estop-out <= [HMOT](CARD0).inm.00.input-04”
“net estop-out => iocontrol.0.emc-enable-in”. Whether my emergency stop button is pressed or not, my limit switches work very well. I have a 12V power supply for the whole system. Is a 24V power supply required?

Thank you

 

Hello,I am responding to your answer because I have a problem with my E-stop. The E-stop on my Axis interface always remains on Off“net estop-out <= [HMOT](CARD0).inm.00.input-04”“net estop-out => iocontrol.0.emc-enable-in”. Whether my emergency stop button is pressed or not, my limit switches work very well. I have a 12V power supply for the whole system. Is a 24V power supply required? Thank you

Does iocontrol.0.emc-enable-in go false when you request an Estop with your switch?

How is the input common on your isolated inputs connected?

Assuming this is a 7I95/7I96/7I96S, the isolated inputs on  these  cards
will work with input voltages from 4V to 36V