Machine moves when you stop program in the middle

Not unless it got there from the easy probe I tried to install.

Thank you for your help, I have had a sick feeling since this started, not because of the lost part but because it didn't seem like I would find the answer. Thank you for helping!!

I think this is all there should be. Maybe more than needed. I will try and get a movie but no promises there.

could you share 'on_abort.ngc'?

I found it finally. I don't see anything in it but here it is. I hope you do. I think I need to try and revert back to before trying to install easy probe.
1- I was unsuccessful in the install (didn't try very hard)
2- not using it since I was unsuccessful
3- never experienced anything like this over the last 12 years or so since finding EMC

If is was something like on abort, shouldn't it do it all the time? I mean like for any program?

Looks fine

If is was something like on abort, shouldn't it do it all the time? I mean like for any program?

Well, yes but since this is an obscure problem it is not likely just related to your hal and ini files.

I think I need to try and revert back to before trying to install easy probe.

Indeed, the easiest would be if you had made a copy of your machine config folder before trying to do the install.

Indeed I wish I had made that copy. But I remember most of the changes. I actually made no changes to .hal or any hal. But changes were made to ini. I can get rid of them.

Does anybody know what this error is? It happens when the machine stops moving after the "random" move.

The distance and direction seems to be related to where the program is in the gcode file.