What board do you recommend for pull/dir for a T3D servo drive?

tommylight wrote:

You can just wire drives directly to IDC26, but that does require caution in proper wiring as those I/O pins are highly sensitive.

This means no BOB.

the breackout board need protection?

thank you for you answer

the pinout or configuration to connect the step and dir where could I find it?

www.sainsmart.com/products/cnc-5-axis-br...stepper-motor-driver
 Is the common breakout I recommend.

You can connect directly to the parallel expansion connector but one wiring mistake
and you may kill the 7I97T

You can check the (DB25) pinout with mesaflash's --readhmid command if you have loaded the
desired firmware into the 7I97T.  You can also check the .pin files in the 7I97t.zip support image.
These are just the result of running mesaflash with the --readhmid option on a 7I97T with the
corresponding firmware loaded.

If you download the latest mesaflash, it has the option of showing the HDR26 pinout (the normal default
is to show the DB25 pinout)

What should I do to not kill my board?

the 7I75 works and I wouldn't have problems making a mistake?