LinuxCNC 2.9 RPi - PNCconf error

More
3 years 7 months ago #267738 by mor
Replied by mor on topic LinuxCNC 2.9 RPi - PNCconf error
Any suggestions for resolving this issue without disabling Advanced Options? I'm trying to use "pncconf -d debug" and need the advanced options to enable board discovery.

Thanks in advance!

Please Log in or Create an account to join the conversation.

More
3 years 7 months ago #267744 by phillc54
Replied by phillc54 on topic LinuxCNC 2.9 RPi - PNCconf error
I have tried PNCconf on 2.9 and I am unable to duplicate this error. I haven't changed anything from the defaults other than enabling Show Advanced Option Pages

Please Log in or Create an account to join the conversation.

More
3 years 7 months ago #267745 by mor
Replied by mor on topic LinuxCNC 2.9 RPi - PNCconf error
I've tried both 2.9 and 2.10 and always have the same issue as the OP.

I'm using RPI 4 with 64-bit PREEMPT_RT and built 2.9 from source.

Please Log in or Create an account to join the conversation.

More
3 years 7 months ago #267746 by phillc54
Replied by phillc54 on topic LinuxCNC 2.9 RPi - PNCconf error
I tried on a Debian 11 arm64 VM (iMac host) with 2.9 built from source. I have a RPI 64 somewhere here, I find it and give it a try.
The following user(s) said Thank You: mor

Please Log in or Create an account to join the conversation.

More
3 years 7 months ago #267747 by mor
Replied by mor on topic LinuxCNC 2.9 RPi - PNCconf error
Just for your reference:
1. Installed latest RPi OS 64-bit.
2. Installed latest available PREEMPT_RT kernel from kdoren GitHub.
3. Built 2.9 from source.

Thanks again for the support!

Please Log in or Create an account to join the conversation.

More
3 years 7 months ago #267749 by cmorley
Replied by cmorley on topic LinuxCNC 2.9 RPi - PNCconf error
on the external controls page, click on 'serial vfd'

Please post an image of that page.

Please Log in or Create an account to join the conversation.

Moderators: cmorley
Time to create page: 0.135 seconds
Powered by Kunena Forum