Sheet Alignment in a Plasma Table

Not that I know of but it is a good idea for sure.

John

I have made some changes to use probing. I didnt realize this thread was here, I found the files on the tutorial section of the wiki.
I did post them on the cnczone forum for linuxcnc.

Here they are if anyone wants to look.

I guess I dont know how to attach files, or zip files arent allowed.

anyways here is the link to the files on cnczone www.cnczone.com/forums/linuxcnc_formerly..._sheet_function.html
I hope thats not against the rules

test hmm I can't add a file either...

Sorry for this noob question but:

I could install the buttons, but when I click on any of then there is a message saying it could not locate the respective ngc file.

Where I have to put these ngc files?

Regards,

Dimitrios

It depends on what path you have configured in your ini file for:
[DISPLAY]
PROGRAM_PREFIX
and
[RS274NGC]
SUBROUTINE_PATH

Note: PROGRAM_PREFIX location is searched before SUBROUTINE_PATH so if you have the same name in both the latter will never get loaded.

JT