Raspberry Pi 4 Tutorial - fatal error

Jim,

I gotta ask what is it that you have that has 662HP with 5.8L? My best is my 385HP 5.7L Corvette.

JT

BigJohnT wrote: Jim,

I gotta ask what is it that you have that has 662HP with 5.8L? My best is my 385HP 5.7L Corvette.

JT

An import ?????

Many can do that without turbo chargers or superchargers. But that 5.8 is suspicious !

Is'nt 5.8L = 351cuin = Ford

Not an import!

2014 GT500. Supercharged 5.8L Dual overhead cam. 662 HP 631FT-LB Torque. 400FT-LB from about 2K to 6500.

That thing was a beast. I don't have it anymore. I had it for 3 years. Drove it a total of 5000 miles and over 1000 miles were put on in two trips. It was black on black on black. While it looked beautiful when it was clean it was never clean. I literally spent more time washing the car than I did driving it.

The main problem with driving it is that it had no traction in 1st gear. you could roll into the throttle and it would start spinning the tires at 50mph.

Most of the time I would demonstrate the power of the car by doing a 60mph roll pull in second gear. You shift from first to second at 62mph. Here is a video of me and my dad in the car doing a 60 to 90 mph pull. Shift to 3rd at 90.



The replacement is a 2000 Ford SVT Lightning pickup truck. It is no GT500 but it will do in a pinch ; )

A little off topic, but you brought it up!

That's pretty impressive, I just can't imagine a supercharger on my corvette! For me 385 HP is plenty in a car that weighs 3,246 pounds and will pull 0.9G's in a corner. Thanks for the video.

JT

Trying to run halcompile on this install on the rpi4 and the result returns
What do I need to do with this install to make halcompile work? I tried to run

while in the emc drectory where the source was downloaded but that does not work either. It returns

Any ideas?