Re:Intel D945GCLF2

I use it few years.
This board is very nice.
But I have problems if GCode programm has 1 000 000 lines e.t.c. because CPU is slow and we have only 2Gb RAM
This board has not any problems with small and medium files.

Thank you all! I just bought this card and goes really well.
Regards Mauro

Witam czy ta płyta Intel D945GCLF2D Atom 330 2x 1,60GHz obsłuży mi linuxcnc 2.7.14 proszę o odpowiedź pozdrawiam i dziekuje.

I use this Mini-Itx computor as the brain for my Maho. It is not the fastest, but has worked flawlessly with my Mesa Hardware.
Mark

jarcysgru wrote: Witam czy ta płyta Intel D945GCLF2D Atom 330 2x 1,60GHz obsłuży mi linuxcnc 2.7.14 proszę o odpowiedź pozdrawiam i dziekuje.

Wheezy most probably, Buster not sure, but download the ISO's, write them to a USB stick and boot from them, you can test LinuxCNC on a Live session:
linuxcnc.org/downloads/

Hello, I installed 2.7.14, I changed the archive source to
deb archive.debian.org/debian wheezy main contrib non-free

deb-src archive.debian.org/debian wheezy main contrib non-free

# deb archive.debian.org/debian wheezy / updates main contrib non-free

# deb-src archive.debian.org/debian wheezy / updates main contrib non-free

deb archive.debian.org/debian-security wheezy / updates main contrib non-free

deb-src archive.debian.org/debian-security/ wheezy / updates main contrib non-free



to have version 2.9 and, interestingly, I can not enter the LPT port number in the configuration, and after entering manually in the hall file 0x378, no engine response, the system is uploaded to the SSD.
What's wrong, for this D945GCLF2 board is too weak for linuxcnc 2.9?