Debian 12 - 2.10 master branch image for the Raspberry Pi 4b/400

I used the meta package  packages.debian.org/bookworm/xfce4
task-xfce-desktop is used by tasksel during a normal debian installation (which is not available for the pi). I think it adds some bloatware we don't need.....Does it install open office?  Thats bloatware to me.

If it does I removed it from the image I’ve made.

Anyways right clicking on the applet identifies it as “NetworkManager Applet” version 1.30.0

I usually boot the image after I’ve created it and do a little bit of “polishing”. Yeah it adds some time as I have to write to the SD card boot and “polish” then read the SD card image and shrink it and zip it up. In all fairness I’m really not making it for a “wider audience”.


Looks like I’ll have my RPi 5 some time tomorrow, unfortunately only a 4GB model as all the 8’s were gone and there was no info about when they’d have stock.
Just hope there’s no issue with the SPI with the linuxcnc driver due to the “southbridge” as they have referrred to the IO chip.

Hahaha I knew a while back you were in favour of office.
forum.linuxcnc.org/18-computer/34823-a-f...d-up?start=20#113495

Just a friendly dig old mate.

Hi!

Just some regular CNCer, already proficient with my rpi4 8gb and 2.8.  I thought I might try something else, test some stuff.  Been reading around here for some days now.  I tried to run that image (the one from Rod's first post):

rpi-4-debian-bookworm-6.1.54-rt15-arm64-ext4-2023-10-21-1847.img

but it gave me that screen (see attached file).  Seems to be hardware related...

Yes, I get that error too on my older Pi  4b
Lots of others have it working for them.. Just hardware I think

Any work around? Switching to a x86 computer?