Compiling linuxcnc with source code on Debian12 resulted in an error

Dear fellow members
I encountered a problem while installing and compiling Linuxcnc from the source code.   ./ configure and make can proceed smoothly, but there was an error with make install: there are no rules to create the target‘ install kernel dep’, which was stopped by the ’install software‘ requirement.
how can i slove it.

There is no "make install" for RIP, after setuid you just set the 'run in place' environment and start linuxcnc, see attached.

Sorry, it still doesn't work. Following the above method still has problems.

After setting the RIP environment, does linuxcnc start?
Just type linuxcnc and hit enter.

Thank you, it can run smoothly now.     I guess it failed because there were Chinese characters in my installation path.Now I want to try how to directly start LinuxCNC and Stepconf Wizard on the desktop, without having to set up the environment in the terminal every time,  as shown in the picture. 
 Your dog is very cute!!!  image missing /media/kunena/emoticons/laughing.png

I'm currently having trouble connecting to ethercat after compiling linuxcnc from source. If you have made further progress on this or ethercat related issues, I hope you can share.
thanks.