screen resolution

gmoccapy_lcd7
Yes, I like it ,for now I see no keyboard in tool table editor

Hello Dinkata, did you reconfigure GMOCappy to 800x600? I also have 10" screen with this resolution, and intend to use it for a Lathe controller.

Mark

RotarySMP wrote: Hello Dinkata, did you reconfigure GMOCappy to 800x600?
Mark

I use gmocappy_lcd 7 on 12" touch screen monitor for Lathe

dinkata wrote:

RotarySMP wrote: Hello Dinkata, did you reconfigure GMOCappy to 800x600?
Mark

I use gmocappy_lcd 7 on 12" touch screen monitor for Lathe

Dang that is a nice setup. I can read "rucen hod" so that is Russian, right?? Meaning "manual movement" ???

Regards,
Tom

I can read "rucen hod" so that is Russian, right??

Yes, it is "manual movement" .language Bulgarian .here's displays





I use external buttons "start / pause / run"
forum.linuxcnc.org/forum/47-hal-examples...-hold-resume-buttons
Not always work correctly , Especially in the program when have M06 change tool .
But this is another topic,excuse my language , i use google translator .

Nice, i have been to Bulgaria over 50 times from 1992 to 1997, in Sofia mostly, but i forgot most of Bulgarian language.
Merci
Tom.