Forum Menu

Photos

More
6 years 6 months ago #165173 by phillc54
Photos was created by phillc54
A place to post photos of cuts you have achieved with PlasmaC.
The following user(s) said Thank You: tommylight

Please Log in or Create an account to join the conversation.

More
6 years 6 months ago #165189 by bbsr_5a
Replied by bbsr_5a on topic Photos
Thank you to all How made this Possible
The following user(s) said Thank You: phillc54, tommylight, CNCFred

Please Log in or Create an account to join the conversation.

More
6 years 6 months ago - 6 years 6 months ago #165199 by taloot
Replied by taloot on topic Photos


last 2 picture done with special chinese plasma
Last edit: 6 years 6 months ago by taloot.
The following user(s) said Thank You: phillc54, joekline9, tommylight, CNCFred, pinder, arcsynapse89

Please Log in or Create an account to join the conversation.

More
6 years 6 months ago - 6 years 6 months ago #165201 by Clive S
Replied by Clive S on topic Photos

phillc54 wrote: A place to post photos of cuts you have achieved with PlasmaC.


It would be nice to have thickness and cut details as well :)
Last edit: 6 years 6 months ago by Clive S.
The following user(s) said Thank You: phillc54, tommylight, CNCFred

Please Log in or Create an account to join the conversation.

  • thefabricator03
  • New Member
  • New Member
More
6 years 6 months ago #165217 by thefabricator03
Replied by thefabricator03 on topic Photos
This was todays work. 25mm plate.

Please Log in or Create an account to join the conversation.

  • thefabricator03
  • New Member
  • New Member
More
6 years 6 months ago #165219 by thefabricator03
Replied by thefabricator03 on topic Photos
I cut these for a project. They are decorative outriggers. Cut from 1.6 hot rolled sheet. I welded them and then ground them flush and had them powder coated.

Please Log in or Create an account to join the conversation.

Moderators: snowgoer540
Time to create page: 0.535 seconds
Powered by Kunena Forum