Forum Menu

LinuxCNC Does not recognize THC

More
6 years 1 week ago #186946 by phillc54
Replied by phillc54 on topic LinuxCNC Does not recognize THC
From the Axis menu: Machine >> Show Hal Configuration >> Pins >> plasmac, select the Watch panel on the right then select the two pins from the tree.

Then you can observe them as the THC controller changes.

Please Log in or Create an account to join the conversation.

More
6 years 1 week ago #186948 by MakingStuff
Replied by MakingStuff on topic LinuxCNC Does not recognize THC
When I watch the move-up and move-down pins in hal config they light up when the THC sets the pins high. The LEDs in the GUI and in hal config do not light up. THC active does not light up either.

Please Log in or Create an account to join the conversation.

More
6 years 1 week ago #186950 by phillc54
Replied by phillc54 on topic LinuxCNC Does not recognize THC

MakingStuff wrote: When I watch the move-up and move-down pins in hal config they light up when the THC sets the pins high. The LEDs in the GUI and in hal config do not light up. THC active does not light up either.

Not sure there...
Is THC Enabled LED lit?
Is VAD Lock LED lit?
Your config does work fine here in a simulator.

Please Log in or Create an account to join the conversation.

More
6 years 1 week ago - 6 years 1 week ago #186952 by MakingStuff
Replied by MakingStuff on topic LinuxCNC Does not recognize THC
THC Enabled is lit.
THC Active is not lit.
VAD is not lit. If I check the VAD check box, it still does not light up.
Last edit: 6 years 1 week ago by MakingStuff.

Please Log in or Create an account to join the conversation.

More
6 years 1 week ago #186953 by phillc54
Replied by phillc54 on topic LinuxCNC Does not recognize THC
Is this with all G-Code files?

Could you post an example.

Please Log in or Create an account to join the conversation.

More
6 years 1 week ago #186957 by phillc54
Replied by phillc54 on topic LinuxCNC Does not recognize THC
Is the Arc OK LED being lit?

Please Log in or Create an account to join the conversation.

Moderators: snowgoer540
Time to create page: 0.180 seconds
Powered by Kunena Forum