Error message axis.z.pos-cmd

More
26 Oct 2019 14:42 - 26 Oct 2019 14:43 #148830 by Edi_48
I have reinstalled my Linuxcnc Debian 9 and Linuxcnc 2.9
I have taken from my old installation only the directory Config.
I have sample Screen 2.0 reinstalled myself to follow the instructions of Vers.by
I start the machine making a reference run
Then I change it on trial screen , I adjust the height of the button (39.50mm) and
Pressing the symbol for measuring the length I get an error message
Axis.z.pos-cmd
Where else do I have to make an attitude
Last edit: 26 Oct 2019 14:43 by Edi_48.

Please Log in or Create an account to join the conversation.

More
26 Oct 2019 17:59 #148847 by tommylight
Can you post a screen shot of the error, please?

Please Log in or Create an account to join the conversation.

More
27 Oct 2019 08:35 #148867 by Edi_48
Replied by Edi_48 on topic Error message axis.z.pos-cmd
Sorry
Error message
Named parameter #<_hal [axis.2.joint-pos-cmd]> not defined

Please Log in or Create an account to join the conversation.

More
27 Oct 2019 11:32 #148872 by pl7i92
Replied by pl7i92 on topic Error message axis.z.pos-cmd
hi
from 2.8 the pinnames have been renamed
you need to change to
axis.z.pos-cmd

Please Log in or Create an account to join the conversation.

More
27 Oct 2019 15:02 #148888 by Edi_48
Replied by Edi_48 on topic Error message axis.z.pos-cmd
And where do I have to change what?
In the macros everywhere is axis.z.pos-cmd

Please Log in or Create an account to join the conversation.

More
29 Oct 2019 15:56 #149061 by andypugh

Sorry
Error message
Named parameter #<_hal [axis.2.joint-pos-cmd]> not defined


This could also be due to G-code access to HAL not being turned on.
(Making this default to "On" is on my list of things to do)

linuxcnc.org/docs/2.8/html/remap/remap.h...i_file_configuration

Please Log in or Create an account to join the conversation.

Time to create page: 0.141 seconds
Powered by Kunena Forum