Raspberry Pi 4

Got linuxcnc working on my RPI4 working over GPIO. Thanks for the information, guys!
still working on hardware stepping on a FPGA, but just wanted to share my progress so far.
Whenever i'm done this will control a Prolight mill.

Can not get Andy´s image to boot. Is there any other img to download?
linuxcnc-pi4.img.zip 2019-07-21 09:34 2.9G

tecno wrote: Can not get Andy´s image to boot. Is there any other img to download?
linuxcnc-pi4.img.zip 2019-07-21 09:34 2.9G

I just installed it from scratch and wrote this tutorial.

gnipsel.com/linuxcnc/uspace/

JT

Started your way, boy does this take time..... phuuu....

And then the install comes to a stop

sudo apt install git >>>>>>>>>>>>>>>>>> NO GO

/usr/lib/arm-linux-gnueabihf:
Bus error
dpkg: error processing package libc-bin (--configure):
installed libc-bin package post-installation script subprocess returned error exit status 135
Errors were encountered while processing:
libc-bin
E: Sub-process /usr/bin/dpkg returned an error code (1)

pi@plasma:~ $ git clone --depth=1 github.com/raspberrypi/linux -b rpi-4.19.y-rt
-bash: git: command not found
pi@plasma:~ $

I've seen network problems prevent the installation of a package, try installing git again.

JT