Setting up AMC BE25A20 in torque mode?

Start
Prev
1
Next
End

Catch22
Topic Author
Offline
Elite Member

27 May 2019 19:23 - 27 May 2019 19:31 #135082 by Catch22

Setting up AMC BE25A20 in torque mode? was created by Catch22

Can anyone help me out, I'm trying to setup Linuxcnc with Mesa 5i25 and 7i77 and AMC 25a20 servo drives, I'm told it's easier and better to have the servos run in torque mode, but I can't seem to find anything that tells me how to do this. I would really like to find a wiring diagram, that would really help me out alot if someone could point me in the right direction, I've searched everywhere and can't find what I need.
Any help would be greatly appreciated.
Thanks Mike

Last edit: 27 May 2019 19:31 by Catch22. Reason: Spelling mistake

Please Log in or Create an account to join the conversation.

cmorley
Offline
Moderator

28 May 2019 04:32 #135117 by cmorley

Replied by cmorley on topic Setting up AMC BE25A20 in torque mode?

AMD used to supply all kinds of manuals now - alot less:

www.a-m-c.com/support/reserved-discontinued/
www.a-m-c.com/wp-content/uploads/support...ual_Analog_Panel.pdf

I am away fom home but if you haven't found a manual in a couple weeks - I am sure i have a PDF

Chris M

The following user(s) said Thank You: Catch22

Please Log in or Create an account to join the conversation.

Start
Prev
1
Next
End

Moderators: PCW, jmelson

Time to create page: 0.077 seconds