from anilam to emc2?

Rick G
Offline
Junior Member

06 Jan 2013 16:27 #28407 by Rick G

Replied by Rick G on topic Re:from anilam to emc2?

Well that got put on the back burner for now, never got past the theoretical stage, perhaps later.
So yes start a new thread and good luck.

Rick G

Please Log in or Create an account to join the conversation.

BigJohnT
Offline
Administrator

06 Jan 2013 21:59 - 07 Jan 2013 01:20 #28414 by BigJohnT

Replied by BigJohnT on topic Re:from anilam to emc2?

~~As it turns out the fellow that started this thread tried to use Mach but never could get it to work.~~

John

Last edit: 07 Jan 2013 01:20 by BigJohnT.

Please Log in or Create an account to join the conversation.

andypugh
Away
Moderator

07 Jan 2013 01:16 #28421 by andypugh

Replied by andypugh on topic Re:from anilam to emc2?

BigJohnT wrote:
As it turns out the fellow that started this thread tried to use Mach but never could get it to work.

Actually, I emailed him and he now has it working nicely on Mach3.
I think he had to buy quite a lot of different hardware.
He was told by guys on the Mach forums that the conversion would take 2 weeks. I told him that for a LinuxCNC conversion (from scratch, first conversion) he should expect it to take 3 months.
So he went with Mach….
It took a year.

Please Log in or Create an account to join the conversation.

ryankracht
Offline
New Member

07 Jan 2013 05:25 #28423 by ryankracht

Replied by ryankracht on topic Re:from anilam to emc2?

Thanks. all.

I started a new thread:

here

Please Log in or Create an account to join the conversation.

Time to create page: 0.066 seconds