Optimizations for Fusion 360?

Hey everyone,

Just sitting down to really optimize my setup since I use it for production now. I'm using Fusion 360 with the LinuxCNC post modified to allow manual setting of G64 Px Qy. Just upgraded to LinuxCNC 2.7.14. Performance is fairly good but I'm still running into a lot of slow downs in trajectory, specifically in morphed spiral operations. Has anyone troubleshooted this already and found an appropriate configuration?

I have considered modifying the post to only use straight lines hoping it would be easier for the trajectory planner to handle. Any help is appreciated.

I know there have been some bugs in the trajectory planner relating to helical paths. Don't know if they have been fixed or even worked on.

Been playing around and G64 P0.005 seems to resolve all feedrate issues on these morphed spiral operations