Raspberry pi 5

Thanks for reply, sirI am already add user rohit to group gpio but same error show.

The error is
HAL_PI_GPIO: can't open /dev/gpiomem: 2 - No such file or directory

/dev/gpiomem doesn't exist

A replied previously
At the moment (2023-07-16) this driver only seems to work on Raspbian as the generic Debian image does not set up the correct interfaces in /dev/gpiomem and restricts access to the /sys/mem interface.

So have will have to start with a Raspbian image, build & install a rt kernel and then build & install linuxcnc.

But just for completeness can you run
and report the result

This problem was already known:
forum.linuxcnc.org/9-installing-linuxcnc...-pi-5?start=0#285243
My advice is to use this new module (hal_gpio) which, in addition to working on Pi 5, in my opinion is more versatile and easier to configure

For changes to be made to .hal files it may be useful to refer to this video
forum.linuxcnc.org/9-installing-linuxcnc...i-5?start=110#290838

Many thanks.

Sir,
Please tell how to change pin status ( input , output, active low and active high) in gpioinfo.

rohit269 wrote:

Sir,
Please tell how to change pin status ( input , output, active low and active high) in gpioinfo.

lloydrochester.com/post/hardware/libgpiod-intro-rpi/