7i77 TB5 Servo enables

More
25 Aug 2021 02:35 #218666 by sprintertrd
Hi Everyone,

Setting up the pin assignments on a 5i25 & 7i77 combo for a router I am building. I know it must be in the software somewhere , but my old eyes I can't find where to assign the servo enables on TB5 in PnCConf.

TIA
Steve

Please Log in or Create an account to join the conversation.

More
25 Aug 2021 03:10 #218669 by PCW
Replied by PCW on topic 7i77 TB5 Servo enables
This should be automatic in pncconf, for example, this is what i get:


net x-enable <= joint.0.amp-enable-out
# enable _all_ sserial pwmgens
net x-enable => [HMOT](CARD0).7i77.0.1.analogena

Note that analogena enables analog channels 0..4
( and turns on the ENA outputs for channels 0..4 )

Please Log in or Create an account to join the conversation.

More
25 Aug 2021 05:49 #218678 by sprintertrd
Replied by sprintertrd on topic 7i77 TB5 Servo enables
Thanks PCW,

I didn't realise it was automatically set and do have those lines in my HAL file.

Now to set up the MPG wheel on encoder5 input.

Please Log in or Create an account to join the conversation.

Moderators: cmorley
Time to create page: 0.164 seconds
Powered by Kunena Forum