Re:pncconf - feature requests

My request would be g540 support. I am not sure if it is applicable based on this post: Post# 33186

I appreciate the work that goes into this. I am willing to make a donation to make this happen. A g540 selection in stepconf was the only reason i got linuxcnc to work.

best regards, Rory

i have purchased MESA 7i92 and 7i77 card for LinuxCNC. While installing i am not Able to Locate it in the system as well as in Pncconfig. Any one pls guide to how use them.

I am new to this and i need support like how to start.

PCW pls look into this.

Sorry the 7i92 is not supported in pncconf.
I don't have hardware to test with.

Chris M

The 7I92 configuration would be pretty much a clone of a 5i25 configuration.

(so one option is to use pncconf to make a 5i25/7i77 config and then edit the hal file to
make it suitable for the 7I92, just globally changing "5i25" to 7I92" is 99 % of the changes)



Differences are these:

Card name is 7i92 instead of 5i25

7I92 is an Ethernet card so it needs the hm2_eth driver instead of hm2_pci
the driver needs the board_ip parameter set to the 7I92s IP address

I/O 0..16 are on the 7I92s P2 instead of P3
I/O 17..33 are on P1 instead of P2

(these connector name changes make no difference in the hal file)

Dear PCW,

I am New to This.

I am not able to see that the 7i92 is detected by linuxcnc.

Please, send me any kind of Step by Step Procedure to use this Card.

S.Perumal
Instrutek Engineers.
India

Dear PCW,

i am in to lot of confusion on Mesaflah and hostmot2, Pncconf..like. Why so, many... why not single graphical interface to do so, only god knows...

i don't know, if at all Mesa selling these cards, they could have developed some kind of graphical interface to get this things done.

when we buy hardware for Mech3, even from china they start work with in an hour,

here in mesa, i have ordered 45 days back. it has came now, and even there is information that the card is presently configured for ????

in linuxCNC there are many Mesa Plugin - go Cards interface has to be updated.

i don't know Why Mesa is Massing up Everything. Directly go to LinuxCNC and select the card and go on.. it should be like that.

This only my Opinion may differ from person to person. but, my exp with low cost Chinese Cards with Mech3 is woks with out Typing single Word. all click away. fantastic..

We also should do something like this for our upcoming new users...

S.Perumal
Instrutek Engineers.
India[/quote]