Unable to finish Pncconf Wizzard
- kmeld
- Offline
- Senior Member
Less
More
- Posts: 53
- Thank you received: 4
02 Jun 2024 14:55 #302160
by kmeld
Unable to finish Pncconf Wizzard was created by kmeld
Hi,
I am trying to set up my machine in linuxcnc and I can't sucessfully do that.
I have new install of linux and linuxcnc from oficial .iso downloaded few days ago.
When I follow Pncconf Wizzard to set up machine on mesa 7i96s card when I get to the last screen where there is "DONE" button configuration is not written.
Instead I get only dialog "do you want to quite".
What should I do?
I am not really a linux user so any suggestions please be very precise and step by step.
KM
I am trying to set up my machine in linuxcnc and I can't sucessfully do that.
I have new install of linux and linuxcnc from oficial .iso downloaded few days ago.
When I follow Pncconf Wizzard to set up machine on mesa 7i96s card when I get to the last screen where there is "DONE" button configuration is not written.
Instead I get only dialog "do you want to quite".
What should I do?
I am not really a linux user so any suggestions please be very precise and step by step.
KM
Please Log in or Create an account to join the conversation.
- PCW
- Away
- Moderator
Less
More
- Posts: 17861
- Thank you received: 4767
02 Jun 2024 15:01 #302161
by PCW
Replied by PCW on topic Unable to finish Pncconf Wizzard
I think pncconf always asks if you want to quit
(just say OK)
(just say OK)
Please Log in or Create an account to join the conversation.
- kmeld
- Offline
- Senior Member
Less
More
- Posts: 53
- Thank you received: 4
02 Jun 2024 15:03 #302162
by kmeld
Replied by kmeld on topic Unable to finish Pncconf Wizzard
Ok,
I figured that out.
Have config files.
KM
I figured that out.
Have config files.
KM
Please Log in or Create an account to join the conversation.
Moderators: cmorley
Time to create page: 0.057 seconds