linuxcnc and 12.04LTS?

Hey guys

Just wondering if there is going to be a linuxcnc 12.04 livecd? given that 10.04 is going to be out of date soon.

P.S.

I have recently upgraded to 2.5.0 from my 2.4.6 livecd install and like what you've done :-D top effort guys keep up the good work.

wont be for a while ... although it works in sim mode only , the realtime kernel is not working , so a lot of work to be done there , which is non trivial
so cannot be used to run machines as yet

Thanks for the reply cncbasher

Seriously APPRECIATED!!! :-D should have figured you guys were on the ball!

have a good one

Alexr