I picked up one of the Odroid H2+ and was going to get your mint ISO installed, but your website is down for me. I'll check back tomorrow, but figured you might want to know it's down incase you weren't already aware.
The website, ISO & packages no longer exist and are no longer available, it has been that way for a week or 2. If other users wish to host/share an image they have there is nothing to stop them from doing that either via a website or a google drive.
Nor will I be providing any further support.
For reasons that I do not and will not go into nor wish to discuss either privately or publicly.
The best bet would to be install Mint 20 & follow Tommy's instructions for installing Linuxcnc on Mint 20. The thread is under the "Installing Linuxcnc" section. Apart from the required NIC drivers there is nothing special about the Odroid, it is just a small form factor x86_64 PC platform. The Odroid wiki has information regarding NIC drivers. The official Odroid forum is another option for support regarding general installation of Operating systems.
BeagleBrainz wrote: The website, ISO & packages no longer exist and are no longer available, it has been that way for a week or 2. If other users wish to host/share an image they have there is nothing to stop them from doing that either via a website or a google drive.
Nor will I be providing any further support.
For reasons that I do not and will not go into nor wish to discuss either privately or publicly.
The best bet would to be install Mint 20 & follow Tommy's instructions for installing Linuxcnc on Mint 20. The thread is under the "Installing Linuxcnc" section. Apart from the required NIC drivers there is nothing special about the Odroid, it is just a small form factor x86_64 PC platform. The Odroid wiki has information regarding NIC drivers. The official Odroid forum is another option for support regarding general installation of Operating systems.
This is all I have to say on the subject.
In that case it would be nice if you did a post on how to change the update packages to point to the correct place etc.
I'm not married to mint, I had just seen that you had compiled the ISO that was all ready to go for this guy. I'm sure I'll be able to figure it out using Tommy's instructions.
