Installing LinuxCNC on Debian 9 - 13

3 years 4 months ago #273835 by tommylight

Replied by tommylight on topic Installing LinuxCNC on Debian 9 - 13

Leaving it to JT to decide.
Thank you.

The following user(s) said Thank You: JT

Please Log in or Create an account to join the conversation.

3 years 4 months ago #273877 by rodw

Replied by rodw on topic Installing LinuxCNC on Debian 9 - 13

Further to this, all of the supported versions can be supported by a single command

Code:

deb http://buildbot2.highlab.com/debian/ bookworm 2.9-uspace" | sudo tee -a /etc/apt/sources.list.d/linuxcnc.list

just change bookworm to bullseye etc and 2.9-uspace to master-uspace to choose between 2.9 and master
Ref: buildbot2.highlab.com/
and this PR
github.com/LinuxCNC/linuxcnc/pull/2529

Please Log in or Create an account to join the conversation.

3 years 3 months ago #274641 by JT

Replied by JT on topic Installing LinuxCNC on Debian 9 - 13

I have had issues in the past combining commands with | and sudo tee... just saying.

JT

The following user(s) said Thank You: rodw

Please Log in or Create an account to join the conversation.

Time to create page: 0.194 seconds