3D printed stuff, showcase it here

That's awesome Tommy!  This takes Benchy to a whole new level!  :laugh:

snowgoer540 wrote:

That's awesome Tommy!  This takes Benchy to a whole new level!  :laugh:

This was 30 cm long, now i have to do one at 60cm on a CR-10 Max, thinking of doing it at half the speed, should be even more detailed.

Now this might end up being useful:





www.thingiverse.com/thing:4539827

this is some next level stuff
freaking Germans man...

You may build a similar machine using LCNC to control it all.

Older analog laser galvos may use the 7i77 for control or make of use of XY2-100 in Mesa hm2 on your Mesa FPGA board of choice. forum.linuxcnc.org/27-driver-boards/3985...ot2-firmware?start=0

The powder spreader and build platform are easily controlled via servo or stepper.

The inert gas valves and build chamber heater using GPIO.

Another Voron Legacy ( vorondesign.com ) being built, by now this has gotten out of hands, badly, since i have over 10 3D printers that rarely get used but i am still building others:


This is more "normal" state of mind stuff, parts for the new cnc plasma machines being built, i forgot when i started building these 3 ...