setup qtplasmac

tommylight wrote:

Just lost over an hour searching fro that info, no luck.
Do remind me, i will write it again sometime ... like not at 3AM !

Thanks Tommy, I seem to remember something about gas solenoids... My memory is shot. image missing /media/kunena/emoticons/blink.png

Hi Phill,
can I ask you to commit new PR? I added a scale for better MPG settings for overriding the Z height.
Some MPGs are too sensitive to adjust Z heigt.
Many thanks.
Martin

 

fupeama wrote:

Hi Phill,
can I ask you to commit new PR? I added a scale for better MPG settings for overriding the Z height.
Some MPGs are too sensitive to adjust Z heigt.
Many thanks.
Martin


 
I can but could you increment the version number, I pushed a .63 a couple of hours ago. 

ok. now it is v 1.0.64.
OK?
Martin

Hi Phill,
I add some more external pins for THC enable, Autovolts, Kerfcross etc.
Pleas can you check new PR and commit it?

PR:
Add external pin for THC, Auto Volts, Cut Rec move etc
#1321

thanks Martin

Thanks Martin, I have posted a comment on the PR.
github.com/LinuxCNC/linuxcnc/pull/1321