Probe Basic 4th Axis plot

Hello, no success

BR anton

Not sure what your are doing but I just tried on 2.9.2:

1. Added this to the [DISPLAY]-section of 'configs/sim/gmoccpy/gmoccapy_XYZAB.ini'

2. start the 'gmoccapy_XYZAB' simulation config
3. open the ngc from your post here: forum.linuxcnc.org/qtpyvcp/51447-probe-b...-plot?start=0#291472

I get this (the work offsets would need to be adjusted for proper preview as I mentioned before)
 

I just notice that you are using 'ProbeBasic'. I'm not familiar with that gui as it is an external project but maybe that has got something to do with it not working on your installation.
 

did you get resolved?

Hello,
No, I didnt resolve it.

mine do not work too....

!BXYZ
!BYXZ

on a older version of Probe_basic or Linuxcnc (i dont know) it worked well...