Woodpecker - 1080x1920 Portrait mode problems

More
21 Dec 2021 23:18 #229678 by hottabich
Lcnc 2.9 RIP. So linuxcnc did not install. Therefore, I cannot help.
The following user(s) said Thank You: spumco

Please Log in or Create an account to join the conversation.

More
21 Dec 2021 23:23 #229679 by spumco
Thank you very much for your time.  I suspected - as usual - it was something on my end.

Please Log in or Create an account to join the conversation.

More
22 Dec 2021 05:27 #229696 by hottabich
Why RIP. Do you still have linuxcnc 2.8.2 installed?

Please Log in or Create an account to join the conversation.

More
22 Dec 2021 06:04 #229701 by spumco
This is my first use of Lcnc and I was trying to install qtpyvcp and Probe Basic, but over the past couple of months the switch to python3 has caused many issues.

As far as I understand (not much) the development version of qtpyvcp needs lcnc 2.9 RIP installation.  And recently some very kind people have posted mostly idiot-proof instructions on how to get Lcnc 2.9 RIP with qtpyvcp & PB installed under MX Linux 21.

So, in short - I don't know why I need RIP, but I followed the directions and it's working.

 
The following user(s) said Thank You: hottabich

Please Log in or Create an account to join the conversation.

More
22 Dec 2021 07:16 - 25 Dec 2021 14:22 #229702 by hottabich
  • (copied (new) woodpecker.ui and woodpecker_handler.py from linuxcnc/configs to /linuxcnc-dev/share/qtvcp/screens/woodpecker)
Copy the entire woodpecker folder from linuxcnc/configs to /linuxcnc-dev/share/qtvcp/screens/ should work. 
Last edit: 25 Dec 2021 14:22 by hottabich.

Please Log in or Create an account to join the conversation.

Moderators: cmorley
Time to create page: 0.098 seconds
Powered by Kunena Forum