2+2+3 More Plasma builds, double the joy ! 3X2M and 2.5X1.5M cnc plasma build.

shpatb wrote: Very beefy set up.I can assume how good that deathadder feels in hands
refresh rate ?

To small for my hands, or in other words i have very big paws!
Refresh is low, 32" one does 70Hz @2560X1440, 24" ones do 60Hz @1920X1200 as they are explicitly made for photo editing, but have very nice colours.

snowgoer540 wrote:

tommylight wrote: modifying QTPlasmaC

Whatcha moddin?

Oh cr@p, did i say that out loud ? Phill gona be anrgy ...
Just made everything a bit bigger as it looked puny on the above mentioned monitors @1920X1200, and i have 4 of them for the 4 machines .... soon.
BTW, i did post a picture of it somewhere.... so here it is again:

Ahh, ok. That’s quite the rapid slider :laugh:

snowgoer540 wrote: Ahh, ok. That’s quite the rapid slider :laugh:

Yup, i use the feed slider quite often when cutting to make fine adjustments.
Adding another shorter slider there to the left would end up looking like showing the middle finger!

No one found the Mesa boards in the above picture ???