My TOS MCV 1000 machining center Retrofit with Siemens 611

Finally got the yellow light!!! The motor has moved. Besides 48 to 9, and 112 to 9, I forgot I should close the relay between NS1 and NS2. When you read the last pages of the manual you sent it all makes sense haha.

Now it’s time for tuning the analog/encoder scales and getting the spindle to run, which I assume will be harder.

Thank you!!

Hello , its been a while but did you succeed in running the simodrive ?

I have the same setup on an Eumach 1050 Heidenhein TNC 407

Nice to know it works for you before I embark on the same mission