Axis run too far
17 Sep 2013 14:56 #38926
by seppel
Replied by seppel on topic Axis run too far
Hello, to close this discussion, here the current status.
I've got now the discribed board and all three axis running very smoothly. In my opinion the chinese board ist absolutly creap. The over running depends probaply on my pc. If I use a special pin pair (not equal pin pair to the chinese board) the axis run too far. Furtunately I've got 4 channels, so I can avoid these pins.
Thaks for your help
I've got now the discribed board and all three axis running very smoothly. In my opinion the chinese board ist absolutly creap. The over running depends probaply on my pc. If I use a special pin pair (not equal pin pair to the chinese board) the axis run too far. Furtunately I've got 4 channels, so I can avoid these pins.
Thaks for your help
Please Log in or Create an account to join the conversation.
11 Jul 2014 07:29 #48628
by malberic
Replied by malberic on topic Axis run too far
Hello Seppel,
do you have a config for the Letmathe Board you can share?
Thank you!
do you have a config for the Letmathe Board you can share?
Thank you!
Please Log in or Create an account to join the conversation.
11 Jul 2014 15:26 #48640
by seppel
Replied by seppel on topic Axis run too far
Hello, my adjusted parameters are
Step Time: 30000ns
Step Space: 30000ns
Dir. Hold: 50000ns
Dir. Setup: 50000ns
Step Time: 30000ns
Step Space: 30000ns
Dir. Hold: 50000ns
Dir. Setup: 50000ns
Please Log in or Create an account to join the conversation.
Moderators: piasdom
Time to create page: 0.065 seconds