× Forum Header

Parallel port config? - probably

Gr8funTargets
Topic Author
Offline
Junior Member

06 Apr 2018 13:44 #108509 by Gr8funTargets

Replied by Gr8funTargets on topic Parallel port config? - probably

Thanks Todd and andypugh for all your help - it is very much appreciated.

For completeness of the thread I have now had a multimeter on the pins of the parallel port and with the use of the port tester here..
wiki.linuxcnc.org/cgi-bin/wiki.pl?Parallel_Port_Tester
I could prove the parallel port is working fine.

Having achieved this, I have now ordered a new BOB as that is the next link in the chain.

ATB
Danny

Please Log in or Create an account to join the conversation.

luka_339
Offline
New Member

04 Oct 2018 10:57 #118439 by luka_339

Replied by luka_339 on topic Parallel port config? - probably

So does this mean that GA-E3800N motherboard works well with linux cnc? The latency is good ?

Please Log in or Create an account to join the conversation.

luka_339
Offline
New Member

01 Apr 2020 18:51 #162366 by luka_339

Replied by luka_339 on topic Parallel port config? - probably

I would like to know that aswell

Please Log in or Create an account to join the conversation.

luka_339
Offline
New Member

01 Apr 2020 18:51 #162367 by luka_339

Replied by luka_339 on topic Parallel port config? - probably

Found my own answer 2 years later

Please Log in or Create an account to join the conversation.

cadsculptor
Offline
New Member

29 Jul 2020 20:21 #176405 by cadsculptor

Replied by cadsculptor on topic Parallel port config? - probably

Hi Luka,
...and, the answer is?

Please Log in or Create an account to join the conversation.

Time to create page: 0.080 seconds