LinuxCNC + Orange Pi (allwincnc)

envyvan wrote:

Hi Cakeslob,

Yes, I just grab them from you posts below.
forum.linuxcnc.org/21-axis/38188-solved-...screen-w-usercommand
I just add the jog select at pyvcp.
 

I see, very nice, I will make it more touch screen/2.8 friendly.

cakeslob wrote:

envyvan wrote:

Hi Cakeslob,

Yes, I just grab them from you posts below.
forum.linuxcnc.org/21-axis/38188-solved-...screen-w-usercommand
I just add the jog select at pyvcp.
 
I see, very nice, I will make it more touch screen/2.8 friendly.
 


 

 

Hi Cakeslob,
That would be nice you to hear you will still keep the GUI mod update.

@envyfan

GUI questions should be on a new thread please.

i'm at work now but once i can upload the photos, yes my card is a 1gb Orange PI PC like yours, so i used your first image to do a little test.

Bari, only the latency test is open plus no window in a few minutes the latency exceeds 100k

Hi Forks,

Seem like SD read and write will lead to huge latency spike. I got 4 glxgears runing 30 mins and I got this.

But after I save the screenshot, Max Jitter comes up to unusable which more then 1000000.

I'm a little out of time to run all the tests as I should, I'm working on another project in my spare time too, but I keep following you guys and testing as I have time