How does axisui work?

What is the difference between (halui.axis.jog-speed) and (halui.joint.jog-speed)

What is the difference between (halui.axis.jog-speed) and (halui.joint.jog-speed)

halui.joint.jog-speed is the jog speed before homing and halui.axis.jog-speed is the jog speed after homing.

See this recent thread for more on the difference between joint-mode and axis-mode:
forum.linuxcnc.org/show-your-stuff/41926...axis?start=10#203212

use halui to hal or ini ?

It's done in hal

Note that you will need some sort of binary signal to replace 'your_signal_plus' and another signal to replace 'your_signal_minus'

Do you want to use external buttons to jog? How to you bring the signals into LinuxCNC?

yes I want to two button to jog forward and backward
I'll try it

thank

I write net jog-x-pos <= HATBUS.Axis0-enable(my signals) => halui.axis.x.plus
but linuxcnc error code 'halui.axis.x.plus' does not exist

so what to work

I write net jog-x-pos <= HATBUS.Axis0-enable(my signals) => halui.axis.x.plus
but linuxcnc error code 'halui.axis.x.plus' does not exist

thank Aciera

I think I understand

thank