7i97t with 7i84d connection problem

I contacted the vendor and they advised me to order a replacement card and send the defective one back for review. They also informed me that all boards were tested before shipping and most defects are user error. Now, I only connected what is shown in the pictures for a quick test and the card was not working from the start.

Can someone confirm if I made any errors connecting it? (Not to prove anything to the vendor but to save me from scrapping another card)

Looks OK, can you verify that you have +24V
on both VFIELDB pins?

I have 24V on the 5 pins to the left of the orange screw terminal.

maybe not on the right place  but ...
i just get one 7i97t and also  two 7i84 card from eusurplus  
where can i find a wire diagrama how to conect the two 7i84 to the 7i97 and also  where and how to conect the shaftencoders and driver inputsignals 

thx in advance  

There is information in the 7I97T manual (page 13)
for making a cable for any Sserial device (like the 7I84)

The 7I97T has a single RS-422 interface so can only connect
to a single 7I84 unless you add and additional expansion daughter
card (or simple 1 chip RS-422 interface) to the 7I97Ts P1 expansion
connector.


Do you have the drive and encoder pinouts?

not at this moment 
i have a little knowledge of working wit the 7i76 but this card is total diferent  
i wil bring a lathe machine back to life its old hardware  with shaftencoders omron e6b2-cwz6c  2500p/r and dc servo drivers  also the spindel is driven by a dc motor and the shaftencoder is available  
had 2 tured toolchange also numerical axe
can i found somewhere here a simular project  so that the wireing is a bit clear to me  also programing help me