- LinuxCNC
- General LinuxCNC Questions
- Getting error "can't do that (EMC_TRAJ_SET_TELEOP_ENABLE) in auto mode"
Getting error "can't do that (EMC_TRAJ_SET_TELEOP_ENABLE) in auto mode"
- andypugh
-
- Offline
- Moderator
-
Less
More
- Posts: 19797
- Thank you received: 4607
18 Feb 2018 14:02 #106132
by andypugh
Replied by andypugh on topic Getting error "can't do that (EMC_TRAJ_SET_TELEOP_ENABLE) in auto mode"
Just trying to catch up. Did you get anywhere with this?
Please Log in or Create an account to join the conversation.
- drewcryan@gmail.com
- Away
- New Member
-
Less
More
- Posts: 1
- Thank you received: 0
16 Feb 2026 08:54 #343040
by drewcryan@gmail.com
Replied by drewcryan@gmail.com on topic Getting error "can't do that (EMC_TRAJ_SET_TELEOP_ENABLE) in auto mode"
Hopefully this helps somebody, I noticed the "skip lines with /" box was checked from your screenshot and it so happens I just got the same error right after I checked it and stopped after I unchecked it, It might be worth looking into. Good luck friends.
Please Log in or Create an account to join the conversation.
- LinuxCNC
- General LinuxCNC Questions
- Getting error "can't do that (EMC_TRAJ_SET_TELEOP_ENABLE) in auto mode"
Time to create page: 0.065 seconds