Toggle button behavior

I have a hal_togglebutton defined and an led associated with it. When Axis first starts I push the toggle button and it changes from Off (red) to On (green). But when I click on it again the toggle button graphic changes like it was clicked but the led does not change back to Off. The button state changes, as I can see it in Show Hal Configuration, but to get it to then turn the led to Off (red) again I have to click it twice. I played with the various settings in Glade for the togglebutton but can't find one that effects the behavior. Any ideas?
Tom

please reproduce the error such that it shows when you run just gladevcp

then post all files here and the commandline, plus any error messages


-- MIchael

mhaberler wrote:

please reproduce the error such that it shows when you run just gladevcp

then post all files here and the commandline, plus any error messages


-- MIchael

Michael,
I am not sure if it an error specifically. I don't think I am getting any error messages but will double check. I will post my config files tomorrow related to the button.
Thanks,
Tom

Nevermind, I am an idiot. I was using a hal toggle button where I should have just been using a regular button. Sorry.
Tom