Remap info
10 May 2021 05:26 #208461
by newbynobi
Replied by newbynobi on topic Remap info
How did you close the tool prepare loop and what about the tool change loop?
If you post your config, we could take a look.
Norbert
If you post your config, we could take a look.
Norbert
Please Log in or Create an account to join the conversation.
11 May 2021 01:50 #208512
by Willheg
Replied by Willheg on topic Remap info
Hello again.
So last night I played round again and found out I had not put a "yield INTERP_EXECUTE_FINISH" command in the remapped m6 code.
As soon as I did this it solved the issue.
Thanks for all your help and pointers again.
Should there be anything else I will be back to ask.
On day I may share the code, as ugly as it maybe.
I get lost on the "try:" areas that people use but it does not seem to hinder what I am doing.
Cheers anyway.
So last night I played round again and found out I had not put a "yield INTERP_EXECUTE_FINISH" command in the remapped m6 code.
As soon as I did this it solved the issue.
Thanks for all your help and pointers again.
Should there be anything else I will be back to ask.
On day I may share the code, as ugly as it maybe.
I get lost on the "try:" areas that people use but it does not seem to hinder what I am doing.
Cheers anyway.
The following user(s) said Thank You: tommylight
Please Log in or Create an account to join the conversation.
Moderators: HansU
Time to create page: 0.111 seconds